COOLİNG TOWER TECHNICIAL SPECIFICATIONS

PACKAGE TYPE WATER COOLING TOWERS HAVE BEEN REALIZED FROM THE FOLLOWING ITEMS.
 

HOT WATER DISTRIBUTION SYSTEMS

With the hot-dip galvanized or epoxy painted steel constructions of natural flow, covered and overflow water distribution system, minimum pump pressure and long service life are ensured. Natural flow water distribution is made by specially designed polypropylene fountains.
 

AIR INPUT BOARD

Air inlet shutters made of hot galvanized or epoxy painted sheet plates: designed to uniformly regulate the air flow and the ice problem is minimized.
 

FISH SEAT SEPARATOR

Due to the fact that separators made of plastic polystyrene guide the air well, low power is drawn from the fan. Easy to check and maintain. Since the separator is installed in a double pass, it keeps the water in the air well. Drift loss is below 02%. Separators can be made of PVC. The high performance filler made of plastic filling polystyrene plastic is specially designed and manufactured to keep the water-air contact at maximum level. Special request can be made from PVC.
 

COOLING TOWER BODY

Design and construction, maximum strength and easy to carry. The tower body consists of ponds and upper body. As standard, it is painted with epoxy paint and special galvanized steel.
 
water cooling tower grp
 
FAN
Specially designed for towers; silent, static and dynamically produced with fully balanced, corrosion-resistant material. Three 19 types (except three nineteen types) are driven by direct coupling, with other types of belt-pulley devices.
 
FAN PROTECTOR
In order to prevent the ingress of foreign matter, the curved fan guard of the round profile iron is manufactured in a detachable type.
 
FAN CYLINDER
It is designed to ensure easy operation of the air to the fan and thus the efficient operation of the tower.
 
WATER FILTER
It is mounted to the pool suction to provide cleaning of the water to the clothes.
 
INTRODUCTION OUTPUT BRASS
The hot water inlet is mounted to the upper pool and the cold water outlet is mounted on the bottom pool.
 
FIXTURES
It consists of feeding float and transport and discharge contacts which can meet evaporation and drift losses.